Duct linking machine is a kind of mechanical equipment for duct joint, the structure is simple, easy to operate, usually used, it can also be used in conjunction with other duct equipment, greatly improving work efficiency. When we use the wind pipe joint sewing machine, have you encountered some problems with the wind pipe joint sewing machine? Today Xiaobian summary of some common faults on the wind duct sewing machine and the reasons for analysis, the following to share with you.
One problem, turning non-stop
Main reasons: lack of butter, to be replaced with new butter; front cover wear, need to change the new on-off valve; strike parts damage, need to remove debris.
Second, the spindle speed is slow
Main reasons: the reverse lever or speed lever position error, to confirm the location; oil is not enough, to be refueled; air pressure is too low, the need to adjust the air pressure.
Question three, only exhaust, do not turn, do not hit
Main reasons: parts damaged parts, the need to change the impact of parts; the lack of butter, to be replaced by new butter.
Fourth, the Ministry of combat strength is insufficient
The main reason: switch valve debris, need to change the impact of parts; spring break, need to change the new spring.
When the air duct manufacturering linking machine when the above problems, do not neglect, to conduct timely processing. Otherwise it will affect the normal use of duct linking machine efficiency.