Notice for production of air duct production line
The air duct production line does not work independently. It exists and operates as a whole production line system. From the volume of material, the process of forming the wind pipe by the machine processing equipment is complete, any part of the end of Chengdu without wind pipe production line, in the operating process to follow the instructions to complete the operation procedures, and pay attention to the following matters.
1. before work, check all parts of the equipment, data and system is in good condition, and open empty car test. It is strictly forbidden to operate without overload. Equipment for wind pipe production line must be operated by hand and cooperate with each other.
2. the operation of the
air duct production line must be performed by professional technicians. Other non personnel are prohibited from working near the pipe line.
3. material selection issues. In the design, manufacture and maintenance, the materials should be selected according to the nature and characteristics of the parts. The material of the wind pipe production line is strictly prohibited from wearing, corrosion, excessive deformation, fatigue, rupture and aging products.
4. assembly quality problems. In this condition, a reasonable initial clearance is required. If the initial gap is too large, the effective life cycle will be shortened; in addition, the accuracy of the position between the parts in assembly is also very important, and if not meet the requirements, it will cause additional stress, partial wear and other consequences.
5. proper maintenance. According to the reasonable process, cost-effective and the principle of possible production, reasonable maintenance and quality maintenance. It is necessary to rationally select and apply the repair process, pay attention to the preparation before the repair, and perform the operation according to the regulations and repair after the repair process.
